Traps alone don't work if the entry points stay open — our Redmond, WA crew seals the building envelope while removing what's already inside. Rodents also gnaw on electrical wiring, which turns a nuisance problem into a genuine fire-safety concern if it goes unaddressed.
Our team is trained in structural exclusion work, not just trap placement — sealing gaps as small as a quarter-inch that mice can squeeze through.
We route technicians fast when a Redmond, WA customer reports fresh droppings, gnawing, or attic noise — those signs mean the population is active now.
No per-trap billing surprises — you get one number covering removal and sealing, quoted after inspection.
We carry snap traps, one-way exclusion doors, thermal cameras for locating nest zones, and sanitation supplies for post-removal cleanup. We also photograph every sealed entry point before and after, giving you documentation of the exclusion work performed.
Norway rats burrow at grade, so we focus on foundation perimeters, deck footings, and crawl space vents.
We trace roof rat entry to soffit vents and roofline gaps, sealing those before setting attic traps.
Mouse control centers on finding every small gap, since a single unsealed opening undoes the whole job.
Rodent droppings and urine-soaked insulation get removed and the space sanitized once trapping is complete.
We install hardware cloth, door sweeps, and vent screens to physically block re-entry after the population is cleared.
Scheduled monitoring and bait station servicing for property managers needing ongoing compliance documentation.
Tell dispatch where you're hearing activity — attic, walls, or kitchen — and whether you've seen droppings or gnaw marks.
We show up prepared to both trap and seal, so there's no separate follow-up trip just to bring supplies.
We trace droppings, gnaw marks, and grease trails back to the entry point, then map every gap needing exclusion work.
Traps are set, entry points sealed, and a follow-up check scheduled to confirm the population is fully cleared.
We'd tried store-bought traps for months. The technician found the actual gap under our deck ledger board in twenty minutes.
Roof rats in the attic for weeks. They sealed three roofline gaps and the noise stopped within a few days.
Property manager here — they service all six of our buildings on a schedule and send logs I can hand to ownership.
Appreciated that they explained the difference between mice and roof rats before quoting. Didn't feel like a guessing game.
Two units in our building had chewed wiring behind the stove. Exclusion work solved it and the electrician confirmed no further risk.
We dispatch Redmond, WA technicians throughout Redmond and neighboring areas, with particular attention to older homes and properties near wooded lots where rodent pressure tends to run higher. We keep an eye on seasonal rodent migration patterns around Redmond, which helps us anticipate calls before they spike.
Rat droppings are roughly the size of a grain of rice or larger; mouse droppings are smaller and more pointed. Noise timing and gnaw-mark size also differ.
Exclusion is the permanent fix — trapping without sealing just clears the current population while leaving the door open for the next one.
Dry sweeping droppings can release airborne particles; it's safer to let the crew handle cleanup with the right protective equipment.
A typical job is a single day of work plus a short follow-up window to verify the population is gone.
We prioritize mechanical trapping and exclusion over rodenticide when possible, especially around homes with pets or children.
Pet food left out, compost piles, and gaps around utility lines are frequent culprits we flag during inspection. It's also worth checking your attic access panel and garage door seal periodically, since those are common secondary entry points we find during follow-ups.
A technician who traps and seals in one visit beats a cycle of traps that never quite finish the job.
Call +1-844-564-2570